Powermate CHFN35P Use and Care Manual download pdf (Page 6)

4- ENG LISH

FEATURES

• Lightweight,magnesiumbodyreducesworkingfatigue.

• Easyclearjamclearing.

• Toolfreedepthofdrive.

• Fastrespeed.

• No-Martipprotectsworksurface.

ASSEMBLY/INSTALLATION

Follow the instructions below to prepare your tool for

operation.

1. All tool operators and their immediate supervisors must

become familiar with the operator safety instructions

before operating the tool.

2. Included with each tool are one copy of these Operating/

Safety Instructions. Keep this publications for future

reference.

3. Install a ﬁlter, regulator, lubricator unit and moisture

trap on your air delivery system per the manufacturer's

instructions for these devices. Additionally, install

a pressure gauge as close as practical to the tool,

preferably within 10 feet (3 meters).

4. Select hoses with a minimum inner diameter of

1/4inch (6.4mm) and a maximum length of 100 feet

(30.5meters).

WARNING

To reduce the risk of injury from a hose bursting, select

hoses that are rated at least 200PSI.

5. Select ﬁttings that are appropriately sized for the

selected hoses. The tool and air hose must have a hose

coupling such that all pressure is removed from the tool

when the coupling joint is disconnected.

WARNING

Never use non relieving couplers and/or female quick

disconnect couplings on the tool. Non relieving couplings

and female couplings will trap high pressure air in the tool

when the airline is disconnected. This will leave the tool

charged with enough air after it has been disconnected

to drive a nail. Only MALE pneumatic type air connectors

should be ﬁtted to the tool, so that high pressure air in

the tool is vented to atmosphere as soon as the airline is

disconnected.

6. Set the regulator at the air delivery system to a PSI that

falls within the tool's operating range of 70-115PSI. The

correct pressure is the lowest pressure that will do the

job.

OPERATION

LUBRICATION

WARNING

USE ONLY THE AIR TOOL LUBRICANTS SUPPLIED WITH

THE TOOL. Do not use other lubricants as they may damage

the tool.

If the tool is not used with an in-line lubrication system on

the air supply it is necessary to periodically lubricate the tool

with air tool lubrication.

Under low use, lubricate once a day. Under heavy use,

lubricate twice a day. To lubricate, insert 2-3 drops of

lubricant into the air supply ﬁtting attached to the tool

handle (FIG 2). Using too much oil will cause it to collect in

the tool and be noticeable in the exhaust.

2–3 Drops of

Air Tool Lubricant

FIG. 2

Do not use detergent oil, WD-40, transmission ﬂuid, motor

oil, or other lubricants not speciﬁcally designated as air tool

lubricants. These lubricants will cause accelerated wear to

the seals, o-rings, and bumpers in the tool, resulting in poor

tool performance and frequent maintenance.

ADJUSTING AIR PRESSURE

Adjust the air pressure at recommended operating pressure

70-115PSI according to the length of nails and the hardness

of workpiece.

The correct air pressure is the lowest pressure which will do

the job. Using the tool at a higher than required air pressure

unnecessarily over stresses the tool. Don't exceed 115PSI.

FIG. 3

70PSI minimum

115PSI maximum

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Comments to this Manuals

No comments

Powermate CHFN35P Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Nail Gun Powermate CHFN35P