Powermate PM0525750 User Manual download pdf (Page 3)

TOOLS REQUIRED: 1/2”, 9/16", and 5/8” sockets and ratchets, block(s) of wood (minimum of 6” tall).

Refer to the parts list on page 9.

WHEEL INSTALLATION

1.Block up end of generator opposite the fuel tank cap to install wheel kit.

2.Insert wheel spacer (item 54) into the center of the wheel (item 58).

3.Slide 3/8 x 3.5” bolt (item 55) through the wheel (item 58)

, then through the wheel bracket on the carrier, with the offset side of

the wheel hub against the wheel bracket.

4.Thread 3/8 nyloc nut (item 53) onto the bolt and tighten to securely clamp the wheel assembly to the tubing.

5.Repeat above instructions for the remaining wheel.

FOOT INSTALLATION

1.Blocking up the stator side of the generator, place a spacer (item 51) and a foot (item 50) under the carrier channel. Thread

a 5/16-18 x 2.75” bolt (item 52) through the mounting holes and thread a 5/16 washer (item 48) and a 5/16 nyloc nut (item 49)

to the bolt to secure the foot to the carrier. Caution: Do not over tighten so that the foot material collapses.

2.Repeat step 1 for the remaining foot.

HANDLE INSTALLATION

1.Place handle (item 56) over carrier tubing on same end as feet, centering handle on the carrier.

2.Slide 7/16 x 2” bolt (item 57) through handle as shown in diagram and secure with 7/16” nyloc nut (item 39). Tighten until

handle is securely clamped to the carrier tubing.

3.Apply aerosol hairspray or similar adhesive to the handle (item 56), and then slide the handle grip (item 60) onto the

handle. The aerosol hairspray will allow for easier assembly and will adhere the grip to the handle.

NOTE: When using a generator cover with this portability kit, the handle must be moved to the downward position.

English

PORTABILITY KIT INSTALLATION

1 2 3 4 5 6 7 8 ... 11 12

No comments

Powermate PM0525750 User Manual Page 3