Powermate PP0100342 Operations Manual download pdf (Page 1)

DANGER

Read and understand this manual completely before operation.

Below information should not be neglected for proper use of this product.

Your understanding can prevent harm or danger to user or others.

SAFETY PRECAUTIONS

Following information is very important for safety in handling this product. Be sure to observe them.

Indicates an imminently hazardous situation which, if not avoided,

will result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided,

could result in death or serious injury.

IMPORTANT

PROHIBITED

ALERT

DANGER

WARNING

Indicates a potentially hazardous situation which, if not avoided,

may resultin minor or moderate injury, or property damage.

CAUTION

Instruction

manual

BEFORE USE

WARNING

CAUTION

Beware of water hammering

Do not allow any vehicle to run over the delivery hose.

Do not close the delivery valve

abruptly because water-hammer

may occur.

This may result in heavy

damage to the pump.

For engine manual and notes, please refer to Engine Operation Manual enclosed.

1. Turn the knob counterclock-wise and remove the knob.

2. Pull the handle towards you, and then both front cover

and volute casing can be removed.

3. Remove the peripheral plug before taking impeller out.

The impeller can be detached by prying loose

with a rod or the like.

4. Draw out the mechanical seal from the engine shaft

along with the sleeve.

NOTE: Please do not hammer an impeller directly when you want to

take it out from

the machine. It might damage the impeller.

Instead, take out the plug set first and then insert something like a rod or tool

which is thin enough to get through the hole and hammer the rod or tool at

the other end. The impeller can be removed out easily without damaging it.

NOTE: When assembling the parts, do not forget to place the adjusting washer,

O-ring, etc., in the right positions. Also, correctly install the front cover

and evenly tighten the right and left knobs.

Note that incomplete assembling may affect the performance o

f the unit.

4-stroke engine needs

"engine oil"

There is

no engine oil in the engine.

Before starting engine, engine oil must be filled. If you start engine without engine oil,

engine will burn out and it is difficult to repair. (Warranty does not cover such claim.)

Please use

"Unleaded Gasoline for Automobile"

DISASSEMBLY AND CLEANING

(

Parts replacement

)

ATTENTION AFTER USE

Avoid fire when refuel or

maintenance.

Highly inflammable!

Do not operate Trash pump

inside a room or under bad

ventilation condition. Harmful

substances are in exhaust gas.

There is danger of gas poisoning.

Do not put any obstacle

around engine muffler.

It may cause fire or breakage.

Read carefully and understand

fully before use.

Do not touch muffler or any

part of the engine. It could

cause burn.

Use correct type of suction hose.

Water temperature tolerance: 5

to 45 . May cause breakage if

use outside the mentioned range.

Please use suction hose for

suction side. Please purchase

suitable hose to fit to connection

dia and suitable length.

Do not use pump on slope.

Fuel spillage at tank cap or

carburetor may cause fire.

In case of operating Trash Pump in

a well or in a hollow, the person

operating the pump must not

enter the small space as there is

danger of gas poisoning.

Do not overhaul or repair,

except by person who is

trained to do so.

Keep children away from

pump when in operation.

Do not run pump without

water inside the pump.

This will cause pump damage.

This pump is not Suitable:

drinking water, seawater, kerosene,

light oil, heavy oil, gasoline,

chemical, acid, alkaline etc.

Please firmly connect hose

with coupling and hose band

when you connect suction or

delivery hose to pump.

Check accessories provided

List of accessories provided are printed in the pump manual.

4-stroke engine

Flammable!! Avoid fire when refuel or maintenance.

Before starting engine, please check if engine oil is filled to required level.

Without engine oil or shortage of engine oil can cause trouble for engine.

Please read carefully Engine Operation Manual for engine oil instructions.

Flammable! Do not operate near open fire.

Any fuel spillage must be cleaned completely.

Check engine oil before operation. Check and refuel periodically.

Please read Engine Operation Manual for instructions.

Stop engine operation when refuelling engine oil.

Engine oil can be very hot after operation.

CAUTION

Make sure suction hose is connected properly

In case of no self-priming after filling pump with water and engine is started, check

suction hose connection carefully again. Most cases of no self-priming are caused

by improper hose connection.

Use suction hose for suction side. Use couplings/hose band as provided

in accessory and attach hose properly. Installation of strainer at the end

of suction hose is necessary.

Please install coupling in order of :

If you install coupling packing not in the above order,

air leakage may result, affecting water suction efficiency.

Coupling

Hose band

Hose nipple Coupling packing

CAUTION

How to install Coupling

Different accessories are suitable for different models.

Please check connection diameter and install correct parts.

CAUTION

Do not change pump diameter by altering suction hose.

Water inside may freeze at below 0 in winter and may damage pump.

After use, drain water from drain plug before storing.

CAUTION

Do not smoke as fuel is highly flammable.

Unused fuel must not remain in the tank for long term

storage. Unused fuel may cause future engine failure.

CAUTION

Drain water after use

After use, remove the drain plug at the bottom and pour water

from the suction/discharge ports so that the remaining sand

is forced out of the pump. If the pump is used to transfer

muddy water over a long period of time, a large volume of

sand will be piled up in the pump casing, making it difficult to remove

the front cover. Therefore, clean the inside the pump periodically.

Long storage

Discharge fuel in fuel tank and carburetor completely. Unused fuel in

tank (if kept more than 30days) may cause engine failure.

*Please refer to Engine Operation Manual.

Do not close delivery

valve abruptly

Collapse of

delivery hose

Drain

Fill pump with water before use

As pump is self-priming type, fill water fully from priming

port into pump before running.

Insufficient water can cause damage to pump.

CAUTION

Running without filling water can damage

mechanical seal.

HOW TO USE

Ensure pump is fully filled up with water.

Ensure strainer at the end of suction hose is in water.

(If any mud or sand is at the bottom of water, suspend hose avoiding the bottom.)

Ensure no obstacle is at delivery hose side.

Priming port

High Performance Self-Priming Engine Pump

11-12 0070101

Pramac America,LLC

P.O.Box 6001 Kearney, NE 68848

1-800-445-1805

• Thank you for choosing a Powermate Trash Pump.

• This manual is prepared for your safety when

operating pump. Please read carefully

and comprehend fully before use.

(Wrong usage could cause injury or death.)

• Please keep this manual handy for future

reference.

1 2

Summary of Contents

Page 1 - Pramac America,LLC

DANGERRead and understand this manual completely before operation.Below information should not be neglected for proper use of this product. Your under

Page 2 - LIMITED WARRANTY

PARTS LISTPP0100342PP0100342Burn out of engineRusting inside engineStuck impellerIntrusion of foreign mattersAir leakage from suction sideOutput power

Comments to this Manuals

No comments

Powermate PP0100342 Operations Manual Page 1

Browse online or download Operations Manual for Engine Powermate PP0100342. Powermate PP0100342 Operation Manual User Manual

Summary of Contents

Comments to this Manuals

Powermate PP0100342 Operations Manual Page 1

Browse online or download Operations Manual for Engine Powermate PP0100342. Powermate PP0100342 Operation Manual User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Engine Powermate PP0100342