Powermate PP1982012.KIT Use and Care Manual

Single Stage, Belt Drive, Electric Air CompressorsCompresseurs d'air électriques à un étage à entraînement par courroieCompresores eléctricos de

10 200-2755Utilisez seulement une rallonge à 3 fils munie d'une prise deterre à 3 lames et une prise de courant à 3 fentes dans laquelle laprise

200-2755 11Ensure that all guards and shrouds are in place before pressing the reset switch to restart the motor.If the motor shuts down because of ov

12 200-2755PUMP SHIPPED WITHOUT OIL. Fill pump to correct mark and check often. Use synthetic, non-detergent air compressor oil.1. Check the level of

200-2755 131. Every day check the sight glass to ensure that the level of oil in the pump is at the required level. The pump oil level must be between

14 200-27551. Placer le manocontacteur en position ARRÊT (C).2. Débranchez le cordon d'alimentation.3. Réduisez la pression dans le réservoir par

200-2755 15To avoid personal injury, always shut off and unplug the compressor and relieve all air pressure from the system before performing any serv

16 200-2755To avoid personal injury, always shut off and unplug the compressor and relieve all air pressure from the system before performing any serv

200-2755 17To check pulley alignment, remove the belt guard andplace a straightedge (see A) against the pump flywheel (see B)(See Fig. 9). Measure and

18 200-2755A dirty air filter will reduce the compressor’s performanceand life. To avoid any internal contamination of the pump, thefilter should be c

200-2755 19Perform the following maintenance at the intervals indicated below.Inspect and clean air filter . . . . . . . . . . . . . . . . . . . . . .

2 200-2755SAFETY GUIDELINES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3OVERVIEW . . . . . . . . . . . . . . . . . . . . . . .

20 200-2755Note: Troubleshooting problems may have similar causes and solutions.PROBLEM POSSIBLE CAUSE

200-2755 21Remarque : Les problémes de dépannage peuvent avoir des causes et des solutions similaires.PROBLÈME CAUSE POSSIB

22 200-2755PROBLEMA CAUSA POSIBLE SOLUCIÓNNota: Los problemas de detección de fallos pue

200-2755 23Item Part No QtyArticle No/ P QtéArtículo Núm / P Cant Description Description Descripción1 034-0226 1 Switch, pressure ...

24 200-2755PARTS DRAWING / DESSIN DES PIÈCES / ESQUEMA DE LA PIEZAS

200-2755 25Item Part No QtyArticle No/ P QtéArtículo Núm / P Cant Description Description Descripción1 N/A 6 Bolt, M8 X 25MM ...

26 200-2755PARTS DRAWING / DESSIN DES PIÈCES / ESQUEMA DE LA PIEZAS

200-2755 27LPV5145 Pump Assy -- Ensemble du pompe -- Conjunto de bombaItem Part No QtyArticle No/ P QtéArtículo Núm / P Cant Description Description D

Replacement parts and service are available from yournearest authorized Service Center. If the need arises,contact Product Service as listed at right.

CAUTION200-2755 3SAFETY GUIDELINESThe following information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize

4 200-27551. Vidangez tous les jours l'humidité accumulée dans le réservoir. Pour éviter la corrosion, le réservoir doit êtrepropre et sec.2. Tir

200-2755 5ADVERTENCIA1. Elimine la humedad del tanque todos los días. Un tanque limpio y seco ayudará a evitar la corrosión.2. Tire del anillo de la v

6 200-2755The basic components of the air compressor are theelectric motor, pump, pressure switch and tank (see Fig. 1).The electric motor (see A) pow

200-2755 7PUMP SHIPPED WITHOUT OIL. Fill pump to correct mark and check often. 10W-30 synthetic oil is recommended for general use.1. Unpack the air c

8 200-2755Refer to Fig. 3.PRESSURE switch (see A)This switch turns on the compressor. It is operatedmanually, but when in the ON position, it allows t

200-2755 9Refer to the air compressor’s serial label for the unit’svoltage and amperage requirements.Use a dedicated circuitFor best performance and r